Boot Process
From Wiki for Dragino Project
There are five LEDs (wifi, LAN, Earth, HeartBeat, PWR) on the Dragino, You can check if your Dragino is booting normal with checking the LEDs.
Set up: Dragino's LAN port connect to your computer's RJ45 port. Set your computer with below IP: 192.168.255.1 and netmask: 255.255.255.0. Use your computer to ping 192.168.255.1 and then power the Dragino, you should see below result:
- PWR is on once you plug in power
- after several seconds, the Earth will be on and the LAN will flash once. this means the Dragino boot to Redboot now. and you can see ping response from 192.168.255.1. this is the default RedBoot IP of Dragino.
- Dragino will continue boot process and your ping should lose connection, after around 2 minutes, the wifi LED will blink and Dragino boot into embedded Linux system.
