Introduction

The Dragino Gateway can commuicate with Helium LoRanWAN Server

Below list the support products and Requirements:

1# LoRaWAN Gateway model:DLOS8,LPS8 DLOS8 LIG16 LG308

2# Firmware version since :lgw--build-v5.4.1625218977-20210702-1744

what you'll learm in this WIKI

1# How to Install Hlelium Server at the gateway

2# How to add up your end-node with Hlelium console

How to Install Hlelium Server at the gateway

Step 1:Choose a frequency that matches

User can choose a frequency from the gateway LoRa page from Web

Step 2: Enter Helium IoT Client from the gateway web

user can enter the gateway web and find the Helium IoT

Step 3: Download the Helium Server

user click Download Helium Server in which the gateway will download the Helium server

Note:Please click Download again if user the gateway no return the Hlium IoT page after the first click Download.

Step 4: Install the Helium Server

User can click the botton of Install Helium Server in which the gateway will Install the Helium Server

Note:User will see the echo charactets of Helium Server has been Installed successfully.

Step 5: Save&start the Helium Server

User can click the botton of Save&Apply in which the gateway will start the Helium Server.

Debug

Check the Helium IoT UI

User can check Helium Server status if it is normol from Helium IoT page

Check the Gateway Log

User can access the gateway wiht SSH Run the command of logread | gerp helium_gateway in which user will see following to check the gateway access Helium server

How to add up user's end-node with Hlium console

Step 1:Login the Helium console

User can Login the Helium Console

Step 2:Add up your end-node's key

User add up end-node's key from console -->dervice

Step 3:Activate the end-node

User can activate the end-node with OTAA in which the end-node will Join the network form Helium server