End Device AT Commands and Downlink Commands
From Wiki for Dragino Project
Revision as of 09:43, 13 September 2020 by Edwin1123 (Talk | contribs) (→Support End Node and firmware version)
Contents
Introduction
Dragino LoRaWAN End Node support two types of Downlink Commands:
- Common Commands: They should be available for each sensor, such as change uplink interval, reset device.
- Sensor Related Commands: Only for special sensor, such as control relay, poll RS485 device.
This page shows the common commands since Dragino LoRaWAN stack DR-LWS-005. Make sure the end node support stack higher than DR-LWS-005 before checking this page.
Support End Node and firmware version
| Dragino STM32 base hardware Firmware / LoRaWAN stack list | ||
|---|---|---|
| Model | Description | Firmware Version ; Stack Version |
| LSN50-v1, LSN50-V2, | Open Source Generic LoRaWAN Sensor Node | LSN50 v1.7.0 <--> DR-LWS-005;
LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005; |
Common Downlink Commands
Downlink Commands List
| Downlink Command Lists | ||
|---|---|---|
| Model | Description | Firmware Version ; Stack Version |
| LSN50-v1, LSN50-V2, | Open Source Generic LoRaWAN Sensor Node | LSN50 v1.7.0 ; DR-LWS-005 |
