End Device AT Commands and Downlink Commands

From Wiki for Dragino Project
Revision as of 09:43, 13 September 2020 by Edwin1123 (Talk | contribs) (→‎Support End Node and firmware version)

Jump to: navigation, search

Introduction

Dragino LoRaWAN End Node support two types of Downlink Commands:

  • Common Commands: They should be available for each sensor, such as change uplink interval, reset device.
  • Sensor Related Commands: Only for special sensor, such as control relay, poll RS485 device.

This page shows the common commands since Dragino LoRaWAN stack DR-LWS-005. Make sure the end node support stack higher than DR-LWS-005 before checking this page.

Support End Node and firmware version

Dragino STM32 base hardware Firmware / LoRaWAN stack list
Model Description Firmware Version ; Stack Version
LSN50-v1, LSN50-V2, Open Source Generic LoRaWAN Sensor Node LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;


Common Downlink Commands

Downlink Commands List

Downlink Command Lists
Model Description Firmware Version ; Stack Version
LSN50-v1, LSN50-V2, Open Source Generic LoRaWAN Sensor Node LSN50 v1.7.0 ; DR-LWS-005
Retrieved from "https://wiki1.dragino.com/index.php?title=End_Device_AT_Commands_and_Downlink_Commands&oldid=7040"