End Device Frequency Band
From Wiki for Dragino Project
Revision as of 20:19, 18 May 2020 by Edwin1123 (Talk | contribs) (Created page with "=Introduction= This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to supp...")
Introduction
This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to support different frequency band or use AT Command to change the sub band in some frequency bands.
- TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html
- Frequency Bands vs Country List: https://www.thethingsnetwork.org/docs/lorawan/frequencies-by-country.html
Default Frequency Bands
KZ865
- Uplink -- 125Khz , DR0 - DR5
- 865.1
- 865.2
- 865.5
- 865.7
- 865.9
- Downlink:
- The RX1 receive window uses the same channel as the preceding uplink.
- The RX2 receive window uses a fixed frequency and data rate. The default parameters are 866.7MHz / DR0 (SF12, 125 kHz)
