Introduction

Dragino Mesh IoT firmware is compiled intend to support both Mesh and IoT.

The firmware can be downloaded from IoT Firmware

IoT-build-20140902-1654 -- v1.2.4

• Fix Upload Arduino Sketch Bug
• Add 115200 indicate string while select Arduino Bridge mode. User should modify the Baud Rate in Arduino IDE --> Library--> Bridge.h from 250000 to 115200 to use the Arduino Bridge class in this image.
• Add Power UART Interface
• Fix CDMA EVDO dial up UI issue.

IoT-build-20140902-1654 -- v1.2.4

• Fix GUI bug to configure device as a WiFi Client.
• Correct opkg.conf link.
• Change config partition from read only to read-write. Firmware upgrade command won't erase this partition
• Add check network connection. User can use Global LED to check connection to specify host.
• Add sensor page to support different avr board.

IoT-build-20140627-1259 -- v1.2.3

• Improve UART for stable transfer to Arduino board.

IoT-build-20140627-1259 -- v1.2.2

• Add Arduino Bridge Support. Baud Rate 115200. This is an Experimental feature, user has change the arduino bridge baud rate (under libraries\Bridge\src\Bridge.h) from 250000 to 115200 to use this.
• Add stty tool

IoT-build-20140616-1526 version 1.2.1

• Fix Firmware Version Display Bug
• Fix DHCP server disable bug.
• Change AP SSID.
• FallBack IP still works after apply change in network.
• Fix DNS1 bug in GUI
• Fix WiFi AP disable/enable bug
• Add default USB modem dial string
• Add better USB support in the GUI.
• Clean Asterisk Script

Web-FailSafe

• A version which use to upgrade the firmware to support Web_FailSafe_Uboot. Instruction.

RC1.1-- 2014 -04

• Change Default SSH log in to root/dragino
• Add support on Arduino IDE, now user can program the avr from Arduino IDE via network connection. Instruction.