Difference between revisions of "End Device AT Commands and Downlink Commands"
From Wiki for Dragino Project
(→Downlink Commands List) |
(→Downlink Commands List) |
||
| Line 32: | Line 32: | ||
|'''Stack Version''' | |'''Stack Version''' | ||
|- | |- | ||
| − | |[[End_Device_Downlink_Command# | + | |[[End_Device_Downlink_Command#0x01_Change_Uplink_Interval|0x01]] |
|Set LoRaWAN payload uplink interval | |Set LoRaWAN payload uplink interval | ||
|DR-LWS-005 | |DR-LWS-005 | ||
Revision as of 09:57, 13 September 2020
Contents
Introduction
Dragino LoRaWAN End Node support two types of Downlink Commands:
- Common Commands: They should be available for each sensor, such as change uplink interval, reset device.
- Sensor Related Commands: Only for special sensor, such as control relay, poll RS485 device.
This page shows the common commands since Dragino LoRaWAN stack DR-LWS-005. Make sure the end node support stack higher than DR-LWS-005 before checking this page.
Support End Node and firmware version
| Dragino STM32 base hardware Firmware / LoRaWAN stack list | ||
|---|---|---|
| Model | Description | Firmware Version ; Stack Version |
| LSN50-v1, LSN50-V2, | Open Source Generic LoRaWAN Sensor Node | LSN50 v1.6.0 <--> DR-LWS-003;
LSN50 v1.7.0 <--> DR-LWS-005; |
Common Downlink Commands
Downlink Commands List
| Downlink Command Lists | ||
|---|---|---|
| Command Code | Function | Stack Version |
| 0x01 | Set LoRaWAN payload uplink interval | DR-LWS-005 |
| 0x04 | Reboot End Node | DR-LWS-005 |
0x01 Change Uplink Interval
Format: Command Code (0x01) followed by 3 bytes time value.
If the downlink payload=0100003C, it means set the END Node’s Transmit Interval to 0x00003C=60(S), while type code is 01.
- Example 1: Downlink Payload: 0100001E // Set Transmit Interval (TDC) = 30 seconds
- Example 2: Downlink Payload: 0100003C // Set Transmit Interval (TDC) = 60 seconds
