Difference between revisions of "End Device AT Commands and Downlink Commands"

From Wiki for Dragino Project
Jump to: navigation, search
(Support End Node and firmware version)
(Support End Node and firmware version)
Line 16: Line 16:
 
|[http://www.dragino.com/products/lora-lorawan-end-node/item/128-lsn50.html LSN50-v1], [http://www.dragino.com/products/lora-lorawan-end-node/item/155-lsn50-v2.html LSN50-V2],
 
|[http://www.dragino.com/products/lora-lorawan-end-node/item/128-lsn50.html LSN50-v1], [http://www.dragino.com/products/lora-lorawan-end-node/item/155-lsn50-v2.html LSN50-V2],
 
|Open Source Generic LoRaWAN Sensor Node
 
|Open Source Generic LoRaWAN Sensor Node
|LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;
+
|LSN50 v1.7.0 <--> DR-LWS-005;
 +
LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;
 
|}
 
|}
 
  
 
=Common Downlink Commands=
 
=Common Downlink Commands=

Revision as of 09:43, 13 September 2020

Introduction

Dragino LoRaWAN End Node support two types of Downlink Commands:

  • Common Commands: They should be available for each sensor, such as change uplink interval, reset device.
  • Sensor Related Commands: Only for special sensor, such as control relay, poll RS485 device.

This page shows the common commands since Dragino LoRaWAN stack DR-LWS-005. Make sure the end node support stack higher than DR-LWS-005 before checking this page.

Support End Node and firmware version

Dragino STM32 base hardware Firmware / LoRaWAN stack list
Model Description Firmware Version ; Stack Version
LSN50-v1, LSN50-V2, Open Source Generic LoRaWAN Sensor Node LSN50 v1.7.0 <--> DR-LWS-005;

LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;LSN50 v1.7.0 <--> DR-LWS-005;

Common Downlink Commands

Downlink Commands List

Downlink Command Lists
Model Description Firmware Version ; Stack Version
LSN50-v1, LSN50-V2, Open Source Generic LoRaWAN Sensor Node LSN50 v1.7.0 ; DR-LWS-005