Difference between revisions of "End Device AT Commands and Downlink Commands"
From Wiki for Dragino Project
(Created page with "=Introduction= Dragino LoRaWAN End Node support two types of Downlink Commands: *<span CLASS=bluetext>Common Commands</span>: They should be available for each sensor, such as...") |
(→Support End Node and firmware version) |
||
| Line 12: | Line 12: | ||
|'''Model''' | |'''Model''' | ||
|'''Description''' | |'''Description''' | ||
| − | |'''Firmware Version | + | |'''Firmware Version ; Stack Version''' |
|- | |- | ||
|[http://www.dragino.com/products/lora-lorawan-end-node/item/128-lsn50.html LSN50-v1], [http://www.dragino.com/products/lora-lorawan-end-node/item/155-lsn50-v2.html LSN50-V2], | |[http://www.dragino.com/products/lora-lorawan-end-node/item/128-lsn50.html LSN50-v1], [http://www.dragino.com/products/lora-lorawan-end-node/item/155-lsn50-v2.html LSN50-V2], | ||
|Open Source Generic LoRaWAN Sensor Node | |Open Source Generic LoRaWAN Sensor Node | ||
| − | |LSN50 v1.7.0 | + | |LSN50 v1.7.0 ; DR-LWS-005 |
|} | |} | ||
Revision as of 09:38, 13 September 2020
Introduction
Dragino LoRaWAN End Node support two types of Downlink Commands:
- Common Commands: They should be available for each sensor, such as change uplink interval, reset device.
- Sensor Related Commands: Only for special sensor, such as control relay, poll RS485 device.
This page shows the common commands since Dragino LoRaWAN stack DR-LWS-005. Make sure the end node support stack higher than DR-LWS-005 before checking this page.
Support End Node and firmware version
| Dragino STM32 base hardware Firmware / LoRaWAN stack list | ||
|---|---|---|
| Model | Description | Firmware Version ; Stack Version |
| LSN50-v1, LSN50-V2, | Open Source Generic LoRaWAN Sensor Node | LSN50 v1.7.0 ; DR-LWS-005 |
