Difference between revisions of "IoT Mesh Firmware User Manual"
From Wiki for Dragino Project
(→INTRODUCTION) |
(→NETWORK SETUP) |
||
| Line 11: | Line 11: | ||
<br> | <br> | ||
| − | =NETWORK SETUP= | + | =TYPICAL NETWORK SETUP= |
| + | This section describes the typical network topology can be set via the Dragino IoT Mesh Firmware. Before setting network parameters, user can set up the <span CLASS=bluetext>Display Net Connection</span> under <span CLASS=greentext>Web --> NetWork --> Internet Access</span> | ||
| + | |||
| + | ==WiFi Client Mode== | ||
<br> | <br> | ||
Revision as of 08:17, 13 November 2014
INTRODUCTION
Dragino IoT Mesh Firmware is designed to use Dragino products for Internet of Things project. This firmware can be loaded in below products:
- Linux IoT Appliance: MS14-S or MS14-P
- Linux IoT WiFi Modyle: HE
- Linux , WiFi Shield for Arduino: Yun Shield
- All other products designed base on HE module
This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a FULL HARDWARE VERSION. Some of above products may not work with a feature if it doesn't have the required connector/peripheral hardware for this feature.
TYPICAL NETWORK SETUP
This section describes the typical network topology can be set via the Dragino IoT Mesh Firmware. Before setting network parameters, user can set up the Display Net Connection under Web --> NetWork --> Internet Access
WiFi Client Mode
