Difference between revisions of "IoT Mesh Firmware User Manual"
From Wiki for Dragino Project
(→INTRODUCTION) |
(→INTRODUCTION) |
||
| Line 5: | Line 5: | ||
*Linux , WiFi Shield for Arduino: [http://www.dragino.com/products/yunshield.html <span CLASS=bluetext>Yun Shield</span>] | *Linux , WiFi Shield for Arduino: [http://www.dragino.com/products/yunshield.html <span CLASS=bluetext>Yun Shield</span>] | ||
*All other products designed base on HE module | *All other products designed base on HE module | ||
| + | |||
This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a <span CLASS=greentext>FULL HARDWARE VERSION</span>. Some of above products may not work with a feature if it doesn't have the required connector/peripheral hardware for this feature. | This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a <span CLASS=greentext>FULL HARDWARE VERSION</span>. Some of above products may not work with a feature if it doesn't have the required connector/peripheral hardware for this feature. | ||
Revision as of 07:37, 13 November 2014
INTRODUCTION
Dragino IoT Mesh Firmware is designed to use Dragino products for Internet of Things project. This firmware can be loaded in below products:
- Linux IoT Appliance: MS14-S or MS14-P
- Linux IoT WiFi Modyle: HE
- Linux , WiFi Shield for Arduino: Yun Shield
- All other products designed base on HE module
This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a FULL HARDWARE VERSION. Some of above products may not work with a feature if it doesn't have the required connector/peripheral hardware for this feature.
NETWORK SETUP
