Difference between revisions of "Temperature Processing Module"
From Wiki for Dragino Project
(→Features) |
(→Features) |
||
| Line 3: | Line 3: | ||
=Features= | =Features= | ||
| − | * | + | *Support devices: |
**DS18B20 | **DS18B20 | ||
**DS1822 | **DS1822 | ||
| Line 9: | Line 9: | ||
*Use ATmega168-20au MCU. | *Use ATmega168-20au MCU. | ||
*Show Sensor ID + Temp pairs as result. | *Show Sensor ID + Temp pairs as result. | ||
| − | *Support 8 OneWire | + | *Support 8 OneWire buses and up to 80 Dallas Temp Sensors in a single unit. |
| + | *Provide 5V power and GND to Dallas Temp Sensors. | ||
*Auto-detect new added sensors or removed sensors. | *Auto-detect new added sensors or removed sensors. | ||
| − | *Remote upgrade | + | *Remote upgrade via internet. |
*Compatible with Arduino IDE for easy debug. | *Compatible with Arduino IDE for easy debug. | ||
*Completely open source in both software and hardware, free to modify and change. | *Completely open source in both software and hardware, free to modify and change. | ||
Revision as of 06:19, 29 September 2012
Introduction
MT-DS is a temperature processing module designed for Dallas Temperature Sensors. This module works as a bridge between Dragino MS12 and Dallas/Maxim Onewire temperature sensors. it read temperature from Dallas Temp Sensors and send it to Dragino via UART port. Dragino MS12 will forward the temp info to remote server.
Features
- Support devices:
- DS18B20
- DS1822
- DS1820
- Use ATmega168-20au MCU.
- Show Sensor ID + Temp pairs as result.
- Support 8 OneWire buses and up to 80 Dallas Temp Sensors in a single unit.
- Provide 5V power and GND to Dallas Temp Sensors.
- Auto-detect new added sensors or removed sensors.
- Remote upgrade via internet.
- Compatible with Arduino IDE for easy debug.
- Completely open source in both software and hardware, free to modify and change.
Feedback and Suggestions
Feel free to send comments or suggestion to Dragino team: info@dragino.com. We will reply you as soon as possible.
Reference Link
About Onewire protocol used in Arduino : http://www.arduino.cc/playground/Learning/OneWire
use Arduino library designed for Dallas Onewire temperature sensor: http://www.arduino.cc/playground/Learning/OneWire
