Difference between revisions of "IoT Mesh Firmware User Manual"
From Wiki for Dragino Project
(Created page with "=INTRODUCTION= Dragino IoT Mesh Firmware is designed to use Dragino products for Internet of Things project. This firmware can be loaded in below products: *Linux IoT Appliance: ...") |
(→INTRODUCTION) |
||
| Line 7: | Line 7: | ||
This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a <span CLASS=greentext>FULL HARDWARE VERSION</span>. Some of above products may not work with the feature if it doesn't have the required connector/peripheral hardware. | This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a <span CLASS=greentext>FULL HARDWARE VERSION</span>. Some of above products may not work with the feature if it doesn't have the required connector/peripheral hardware. | ||
| + | |||
| + | |||
| + | =FIRMWARE RELEASE NOTE= | ||
| + | [[Mesh_IoT_Firmware|Mesh Firmware Release Note]] | ||
Revision as of 07:35, 13 November 2014
INTRODUCTION
Dragino IoT Mesh Firmware is designed to use Dragino products for Internet of Things project. This firmware can be loaded in below products:
- Linux IoT Appliance: MS14-S or MS14-P
- Linux IoT WiFi Modyle: HE
- Linux , WiFi Shield for Arduino: Yun Shield
- All other products designed base on HE module
This page is a user manual for the Dragino IoT Mesh Firmware. The manual is written as a FULL HARDWARE VERSION. Some of above products may not work with the feature if it doesn't have the required connector/peripheral hardware.
