Difference between revisions of "End Device Frequency Band"
From Wiki for Dragino Project
(Created page with "=Introduction= This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to supp...") |
|||
| Line 1: | Line 1: | ||
| − | =Introduction= | + | *=Introduction= |
This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to support different frequency band or use AT Command to change the sub band in some frequency bands. | This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to support different frequency band or use AT Command to change the sub band in some frequency bands. | ||
* TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html | * TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html | ||
| Line 16: | Line 16: | ||
**The RX1 receive window uses the same channel as the preceding uplink. | **The RX1 receive window uses the same channel as the preceding uplink. | ||
**The RX2 receive window uses a fixed frequency and data rate. The default parameters are 866.7MHz / DR0 (SF12, 125 kHz) | **The RX2 receive window uses a fixed frequency and data rate. The default parameters are 866.7MHz / DR0 (SF12, 125 kHz) | ||
| + | |||
| + | |||
| + | =Frequency Bands for different server= | ||
| + | * TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html | ||
| + | * Loriot https://docs.loriot.io/display/LNS/Regional+Frequency+Plans | ||
Revision as of 05:55, 22 May 2020
- =Introduction=
This page list the default frequency band for Dragino End Devices. The frequency bands are base on TTN Frequency Bands. User can modify upgrade firmware to support different frequency band or use AT Command to change the sub band in some frequency bands.
- TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html
- Frequency Bands vs Country List: https://www.thethingsnetwork.org/docs/lorawan/frequencies-by-country.html
Default Frequency Bands
KZ865
- Uplink -- 125Khz , DR0 - DR5
- 865.1
- 865.2
- 865.5
- 865.7
- 865.9
- Downlink:
- The RX1 receive window uses the same channel as the preceding uplink.
- The RX2 receive window uses a fixed frequency and data rate. The default parameters are 866.7MHz / DR0 (SF12, 125 kHz)
Frequency Bands for different server
- TTN Frequency Band Settings: https://www.thethingsnetwork.org/docs/lorawan/frequency-plans.html
- Loriot https://docs.loriot.io/display/LNS/Regional+Frequency+Plans
