Difference between revisions of "Temperature Processing Module"
From Wiki for Dragino Project
| Line 19: | Line 19: | ||
=How to use this module= | =How to use this module= | ||
| + | ==About OneWire Protocol== | ||
| + | ==About Dallas Temperature Sensors== | ||
| + | ==Configuration== | ||
| + | |||
| + | =Version Info= | ||
| + | |||
| + | =Hardware / Software Source= | ||
| + | http://svn.dragino.com/examples/MT-DS | ||
| + | |||
| + | =Ordering Info= | ||
=Feedback and Suggestions= | =Feedback and Suggestions= | ||
Revision as of 07:09, 29 September 2012
Contents
Introduction
一个MT-DS模块的单独图片
MT-DS is a temperature processing module designed for Dallas Temperature Sensors. This module works as a bridge between Dragino MS12 and Dallas/Maxim Onewire temperature sensors. it read temperature from Dallas Temp Sensors and send it to Dragino via UART port. Dragino MS12 will forward the temp info to remote server.
Features
- Support devices:
- DS18B20
- DS1822
- DS1820
- Use ATmega168-20au MCU.
- Show Sensor ID + Temp pairs as result.
- Support 8 OneWire buses (with pull up 4.7K Ohm resister) and up to 80 Dallas Temp Sensors in a single Dragino.
- Provide 5V power and GND to Dallas Temp Sensors.
- Auto-detect new added sensors or removed sensors.
- Remote upgrade via internet.
- Compatible with Arduino IDE for easy debug.
- Completely open source in both software and hardware, free to modify and change.
How to use this module
About OneWire Protocol
About Dallas Temperature Sensors
Configuration
Version Info
Hardware / Software Source
http://svn.dragino.com/examples/MT-DS
Ordering Info
Feedback and Suggestions
Feel free to send comments or suggestion to Dragino team: info@dragino.com. We will reply you as soon as possible.
Reference Link
About Onewire protocol used in Arduino : http://www.arduino.cc/playground/Learning/OneWire
use Arduino library designed for Dallas Onewire temperature sensor: http://www.arduino.cc/playground/Learning/OneWire
